I come to you!
the last post on the rag (Tutorial Part I) I had come to tell you how to build the blocks with the padding and then quilted.
Let's just say that this was the greatest work.
Now we must join them.
I suggest you divide the whole quilt in three large blocks formed by strips / file-square width. If
prepared individual file blocks and units one at a time you find yourself having to drag the hand to hand quilt that weighs a lot. So you better join the ranks of three to three and finally sewing these large blocks of each other.
My rag quilt weighs 2 pounds and 300 grams! .... Before you add the last piece I had a snack:)
As for the seams, it is obvious that we must switch crease in the margins, otherwise it gets really thick too, one in one direction and one in another ...
and it is preferable that what is going in for us: not being able to watch, so it is difficult to move. While what we have in the top view runs counter to the seam.
Begin by matching the corners of the first two overlapping blocks and intersections of the end of the two blocks.
holding lock them firmly and continue sewing.
So if there are small differences of a few millimeters will be void.
As you go check if they match the intersections of the squares below, in order to provide for other differences and pull a little bit more to match the crosses.
Another important thing is that we need to repeat twice the seams.
Being a quilt that will be a little heavy, I think it's safer to do the double seam.
Before making the second removed the basting stitch! otherwise you will set stubbornly and in some areas will be difficult to remove.
I figured I would remind you that 2 cm margins which will be what ultimately will form the fringes.
Even these boards can be cut to form the fringes, but I have not yet decided whether it will put a woolen fabric on the bias to form a nice edge, covering the fateful course 2 cm. Aesthetically
perhaps prefer, not only for the consistency that will give the board (in the case of the fringes will inevitably taper off), but imagining the colored border will be seen on the back, where there are denim, I think it can be a better variant.
I do not know if in the end opt for the latter variant, also depends on the time that still want to dedicate.
Finally, cutting the fringe: my scissors would need a good burr.
the same job, but I have to repeat the movement of the cut several times. It is not just a walk, but above all increase the chances of making any cut where not needed! ... I have met, but I have to be careful.
Therefore, I recommend a very useful pair of sharp scissors.
You will make much less effort and speed things up and intact.
Where's my rag over? ... you'll see in a future post:)
...
No, here it is!